Tuesday, March 1, 2011

Barbie Bed -- A Dollar Project!

Hee hee! I am tickled by today's project for Dollar Store Crafts. But, then again, you know me and tiny things -- I just love them! Can you guess the source of my doll bed frame and comforter?


The comforter and pillow were made from a dollar store pillow cover -- with fabric to spare -- and the bed frame was made from two wooden "Zen Garden" trays, also from the dollar store. I have had my eye on those for over a year, knowing they had great potential. Finally the perfect project to use them for!

Here's what I used:
~ One pillow cover (lots of prints and fabrics to choose from!)
~ Two Zen Garden trays
~ Scrap of eyelet trim (for the bed skirt)
~ Scraps of white fabric (for the mattress and bed skirt)
~ Scraps of polyester batting
~ Also need: sand paper or utility knife, wood glue, finish nails, saw

(pardon the lighting on this photo and the next one, taken down within the depths of the basement!)
First we will need to construct the bed frame. My husband was kind enough to tackle this part of the project for me!
STEP ONE: Measure and mark ONE of your Zen Garden trays 3 5/8" from one end and carefully saw. The longer piece will be the headboard, and the shorter piece will be the foot of the bed.

STEP TWO: With both cut ends together and the two tray pieces back to back, use a sharp pencil to draw a line on the headboard piece, marking the height of the foot of the bed, as shown.

STEP THREE: You will be butting the shorter end of the first tray (the foot of the bed) against the short end of the second (uncut) tray. The cut side will be the part of the bed that touches the "floor." Lightly sand (or in our case, since we had no sandpaper handy, scrape with a utility knife) JUST the two surfaces that will be touching. This will help the wood glue to hold. Use a thin layer of wood glue, then carefully nail one finish nail on either end for a sturdy hold.


STEP FOUR: Now for the headboard. Again, carefully sand or scrape the two surfaces that will be glued together. Your drawn line will be where you line up the TOP of the long tray. We glued and then used a staple gun to hold the headboard in place.

Allow the glue to dry!

STEP FIVE: Now we're getting to the fun part -- the sewing!
I started by carefully removing the zipper (to save for a future project!) and then cutting along the seam lines of the pillow cover. Set your pillow cover fabric aside.

STEP SIX: Make the bed skirt! Cut as follows:
Center piece: 11" x 4 1/4"
Ruffle pieces: Two rectangles, 14 1/2" x 4"

Hem the two short ends of all pieces, and one long end of each of the two ruffle pieces, by turning the edges up 1/4" and sewing. Gather the raw edge of the two ruffle pieces a scant 1/4" from the edge. Attach to the long edges of the center piece. Your bed skirt should look like the photo.

STEP SEVEN: Make the mattress! Cut two rectangles, 12 1/2" x 5 1/4". Sew all the way around with a 1/4" seam allowance.

Open each corner as shown and sew a line 3/8" from the point, perpendicular to the seam line. This will box the corners of your mattress.

Cut a 6"-8" slit down one the center of one rectangle and turn it right side out. Carefully stuff with a stack of batting and whipstitch the opening closed.

Bed skirt and mattress? Check!


STEP EIGHT: Make the comforter! Cut two rectangles, 9 1/2" x 13 1/2". Layer them right sides together and sew three sides, leaving one short side open. Trim the corners as shown and turn right side out. Carefully tuck the raw edges inside 1/4" and press. Topstitch all the way around, closing the opening as well. Done!

STEP NINE: Make the pillow! Cut two rectangles, 5 1/4" x 3 3/4". Sew right sides together using about a 1/8" seam allowance, leaving a 2 1/2" opening on one short end. Turn right side out.

Topstitch right along the edge on the three finished sides, then 1/4" from your stitching line.

Stuff with another stack of batting. Carefully tuck the raw edges inside and topstitch the opening closed, then sew 1/4" from that stitching line.

Everything's done! Time to make the bed!
I topped my little bed with a tiny embroidered sachet that belonged to my grandmother. It makes a perfect accent pillow!

Barbie is all set to relax and read a book!

19 comments:

KJ@letsgoflyakite said...

Absolutely precious!!! love it, love it, love it.

Emily said...

That is just too cute!

Wendy said...

I think 1962 Grandma Barbie may need one! I love it!

Georgette said...

CUUUUUTE! so creative!

Anonymous said...

them barbie beoches are so spoiled. Why couldn't I have learned to sew when I was a kid. Maybe Kirby needs a bed!

Denise said...

So cute! Wish I was young enough to play with it all day ;)

Becky Marie said...

simply.awesome!!

Cheri said...

So very clever! Just adorable.

the Kates said...

So Cute and Clever, Care! I love it!

elsie said...

What dollar store did you buy your Zen Garden trays? They would be perfect for so many projects.

Care said...

Elsie,

Dollar Tree! Each one also comes with a little bag of sand, some river rocks, and a little wooden rake. Good times!

Care.

Kari Sweeten said...

K, this is super cool and would be perfect in the new dollhouse!!

Mama Teaching 3 said...

That is so cute! :) If I lived closer to my nieces I would always come up with things like this. Wonder if my boys will play with the barbie bed?

They do have the zen garden...

Amy said...

This is so cute!! Also wanted to mention that I think this would be cute without the skirt and more modern bedding.

Sam Ericas said...

Thanks for share a nice tutorial
Baby Gears Pro

Rogger said...

https://bestelectricbikeunder.com/ Electric bike buyers guide, with unbiased and honest reports and detailed analyses of all the latest and fastest ebikes, conversion kits and hub motors.

kopi.J said...

Hello! I think these information Will be helpful for you.

esprm2014.com
myoceanhousecondo.com
Thank you!

boy said...

This is my blog. Click here.
karmidimp3"
erlangpatterns"

edok69 said...

Suggest good information in this message, click here.
ufabet วิธีเล่น
Slot online